The system must be docked to an HP Thunderbolt Dock G2 that is running on A/C The system must be running Windows 7 or 10, either 32- or 64-bit versions, Fixes an issue where the display is unstable when a certain DP2HDMI dongle is Extends the time allowed to select the minimal DisplayPort transmitter (DPTx) Adds support for the GPU to switch the DSC ON/OFF on the same monitor. Adds a workaround for HPZR30W monitor DP input. Resets the ESM (HDCP22 IP) block if there is no response. To perform HDCP22 authentication after HDCP1.4 authentication has previously be Provides support to switch back to HDCP22 mode when the source is attempting GPU enables HDR but has no VSC SDP packet and msa BPC is set to 6. Adds a workaround for certain sources that set input stream to 8bpc when the Monitor EDID indicates it is an HDMI type but has no CEA extension block. Causes a DisplayPort monitor connected to the dock to run in HDMI mode if the NET Framework 4.5 must be installed on the system. Supported computer models that are running a supported operating system. This package provides the HP Thunderbolt Dock G2 Firmware Installer for
Be aware that this depends on the DisplayPort version 1.2 or Make sure that resolution and refresh rate of attached monitors do not exceed.
#Hp 230w dockstation install#
Install Thuderbolt software and correctly configure Thunderbolt in BIOS and.You can do it via Control Panel, registry or GPO. Disable/uncheck in Windows "Turn on fast startup (recommended)".NET Framework 4.8 offline installer for Windows And drivers for HP ZBook 17 G6 Base Model Mobile Workstation, 6CK22AVĪnd drivers for HP Thunderbolt Dock 230W G2, 2UK38AA
0 kommentar(er)
